Apex SW01:i Aluminium and carbon fibre steering wheel

Apex SW01:i Aluminium and carbon fibre steering wheel

The Apex SW:01i is an aluminium and carbon fibre steering wheel designed to fit a number solutions.

The chassis is machined from a single block of 6061 grade aluminium and anodised black. The handgrips are made of carbon fibre coated with a military grade rubber coating.

Fitted with a CAN board for direct communication to your car’s ECU. The wheel can be configured in many ways utilising the 8 push buttons inputs and 8 analog inputs on the CAN board. A typical set up would be 10 push buttons and two rotary switches.

The specification of the CAN board is as follows -

CAN BUS 2.0B

500 or 1000kbps, user selectable

Different CAN ID and CAN frame structures can be selected

8 switch inputs (switched to ground)

8 analog inputs / rotary switch inputs, 0-5V, 10bits

4 low side outputs (0.5A, resistive and inductive loads)

+5V output for powering rotary switches, sensors and potentiometers

Firmware upgrade over the CAN bus

The SW:01i has a diameter of 270 mm and the ergonomically designed hand grips make this a really user friendly tool. It can be customised in many ways with paddle shifters, buttons, rotary switches and encoders.

The price shown is for the model fitted with the CAN board as described above.

If you would like paddle shifters add them to the order and select your paddle choice and they will be fitted to the wheel.

Get in touch for further options

    £750.00Price